moblite6 3D Models

Camera Holder TPU for Moblite6 and Moblite7

Camera Holder TPU for Moblite6 and Moblite7

Moblite7 Protector

I designed a little protector for the moblite7. I don't weighted the piece but in cura ...

Moblite7 canopy

light weight canopy for Moblite7 and Moblite6. various holes allow for different camer...

Moblite7 Canopy

This is a remix of AngryDonFPV's Canopy to allow the front mount to slide over the post...

moblite canopy

a tiny whoop canopy with a fixed cam angle. The options are 15,20 and 25 deg.

moblite canopy

this is a remix from angry don moblite canopy to add a fin too make the turtle mode eas...

Moblite7 Frame + Upgrades

Hello, i crashed my frame and i also wanted to upgarde my Moblite7. so i designed a...

Moblite7 battery holder

I re-remixed the following to add a thin section to the bottom opening as I printed in ...

Moblite7 Camera Mount

I designed this for the Moblite7 to mount a camera on top of the flight controller. Thi...

Moblite7 FC Cover

The Moblite7 and Moblite6 are both highly rated FPV drones but the Flight Controller is...

Moblite Case Insert

I wanted to carry two whoops in my moblite case plus batteries. This is my solution. D...

Moblite 7 Case

This is a simple case to protect the Moblite7 when transporting it. I didn't make a li...

Moblite 7 Canopy

Intended for new pilots practicing indoor, for slow flying and hovering. Camera angle i...

Moblite7 electronic protection cover

I saw some reports that electronic was damaged when moblite7 fails on back, so this is ...

Moblite7 1S battery holder

The Happymodel Moblite 7 has a battery holder for 2S, the walksnail model is 1S and the...

MobLite7 300 mah holder

I wanted the mobilite7 to be light and nimble and use a 300mah, as it is intended for a...

Moblite7(or 6) Canopy

This is a canopy for Moblite 7 (6). 20 degres cam angle canopy.

Camera Wedge for Moblite7

A 15° camera stabilizer for Moblite7 or Moblite6. Replaces the original piece of foam. ...

Moblite7 Insta360 Go mount

An Insta360 Go mount for HappyModel Mobulite7. BTW - This is a remix from https://w...

Moblite7 electronic protection cover

I saw some reports that electronic was damaged when moblite7 fails on back, so this is ...

Moblite 7 Insta360 Go2

Insta360 Go2 mount for Happymodel Moblite 7

Moblite 6 Race Canopy

This is a solid 15 degree camera mount. The camera presses into the mount, so its a ti...

Moblite 6/7 Canopy

Remixed a canopy model : - Added camera tilt - Added Flight Controller protection ...

Moblite 6 Race Canopy

I designed this for the moblite 6 with the help of RCgroups support. The weight ra...

Moblite 7 and Moblite 6 tiny whoop electronic protection cover

Mobulite electronic protection

It's a remix to protect standard size AIO board in case you would like to convert your ...

moblie phone

使用過的手機，有些髒以及刮痕

Moblie Stand

Stand for mobile

Moblie holder

SAMSUNG MOBLIE

MOBLIE PHONE